Recently customers had been experiencing an error when trying to update code on the Kaimana Minis. We looked into it and realized that the Kaimana Mini was not resetting when uploading the code like it should. The work around for this is to start the upload of the new code and then to manually reset the board. The way to manually reset your board is to touch the two front pins with a piece of metal, in the picture here a screw driver was used.

So the directions are.

1. Sketch and upload your code

2. After you click upload touch the two prongs like in the picture.

After this you should hear the USB make the disconnect and connect noise. Your code should now be properly uploaded.

We apologize for the glitch and appreciate your understanding.